![]() Simply attach pipes to any of the four pipe connections (one pipe for incoming water, one for outgoing water), and if you pump cold water into the reactor, it will reduce the core temperature, and come out as hot water. In the ECCS water is used to cool down the reactor core. You need to send the control signals here, if you want to make the reactor change its state. It outputs all important information as signals (see below for details on the signals). The circuit interface is the part, where you can interact with the reactor. You can click the reactor core to open it and insert the uranium fuel cells, or right-click it to remove the reactor (only possible when the reactor is in the stopped state). You need to attach the heat pipes to any of its heat pipe connections (see the flame symbols when you mouse-over it). The reactor core is the part, where the nuclear reaction is happening. The nuclear reactor consists of three elements: the reactor core, the circuit interface and the Emergency Core Cooling System (ECCS): To stop the nuclear process, either let the reactor run out of fuel cells, or send the Scram Control Signal to the interface.īe aware that the scram process takes some time and the reactor will still produce heat until it is fully stopped. The reactor is now producing heat at a certain efficiency (->see the two corresponding signals on the circuit interface). ![]() To start a nuclear reactor, you need to insert fuel cells and send the Start Control Signal to the circuit interface. The cooling tower is used to cool down hot water or steam coming from the ECCS or other parts of the plant. The reactors need to be controlled with signals via the integrated circuit interface, and they need to be cooled over their Emergency Core Cooling System (ECCS), otherwise they might get too hot causing a reactor core melt down. extra empty fuel cells).īoth reactors power output and fuel efficiency is dynamic depending on the temperature they are operating on, and also depending on the setup of your plant. The normal reactor has a high power output, the breeder reactor has a medium power output, but produces bonus materials (i.e. ![]() This mod adds a nuclear reactor, a breeder reactor and a cooling tower. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |